Keywords - Siemens SINUMERIK 840C Installation Instructions Manual

4 MMC Area Diagnosis
4.4.2 Configuration file CONFIG

4.4.2.1 Keywords

Keywords are words reserved by the system.
The following keywords exist:
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
1) Up to SW 2 only
2) SW 4.4 and higher
3) SW 5 and higher
4–26
LANGUAGE Language set for NCK and MMC
LANGUAGE1 Language set for WOP
LANGUAGE2 Language set for simulation
LANGUAGE3 Language set for PG function
LANGUAGE4 Language set for user
BT_NAME FlexOS name of the operator panel interface
BT_PARAM Name ""; operation without operator panel
PROTLEN1 Size of the alarm log in number of messages
PROTLEN2 Size of the service log in number of messages
FLUSHLEN1 Maximum number of messages buffered for the alarm log
FLUSHLEN 2 Maximum number of messages buffered for the service log
FLUSHTIME Maximum buffering time for messages in milliseconds
PROTMASK1 Type of messages to be entered in the alarm log
PROTMASK2 Type of messages to be entered in the service log
PRIO_PO Display priority of NCK alarms with alarm type "power on"
PRIO_RE Display priority of NCK alarms with alarm type "reset"
PRIO_CA Display priority of NCK alarms with alarm type "cancel"
PRIO_PA Display priority of PLC alarms
PRIO_PM Display priority of PLC messages
PRIO_KO Display priority of NCK comments
SYSFONT Defines the character set in the configuration file of the
master control
TFORMAT Format in which the times are to be written to the log
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
3)
3)
3)
3)
1)
1)
1)
2)
SINUMERIK 840C (IA)
09.95
1)
1)
1)
1)