Plc General Reset; Procedure For Starting Up The Plc - Siemens SINUMERIK 840C Installation Instructions Manual

09.95
S
Restrictions
S
S
S
3.3

PLC general reset

3.4

Procedure for starting up the PLC

Overview
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
SINUMERIK 840C (IA)
The data management function BTRIEVE is not installed.
For output on the printer via the parallel interface parallel 1 (Centronics, X122)
on the MMC-CPU, LPT1 must be set in the printer parameters.
The following characters cannot be displayed on the operator panel: "#", "{", "
}", "~", "'", "$", "&", " |", "\"
Data exchange with external PGs can only be performed with the FD-E2
diskette unit.
PLC general reset
With NC operator panel
Select general reset
mode PLC general reset
See Section 2
General reset
Load user program
File ANW_PROG
exists
Check
– Operator area Services
– SK Data management
– Dir. PLC/program.
3.2 PG function via MMC
or
PG 7xx
See
Programming Guide
Load Step 5 program
into PLC 135 with PG
Load WD
Back up PLC prog. on disk,
in general reset mode.
3 PLC Installation
3-5