Plc Configuration And Plc Machine Data (As From Sw 3); Plc Configuration - Siemens SINUMERIK 840C Installation Instructions Manual

5 Machine Data Dialog (MDD – as from SW 3)

5.3 PLC configuration and PLC machine data (as from SW 3)

5.3 PLC configuration and PLC machine data (as from SW 3)
5.3.1

PLC configuration

Selection
The PLC configuration display appears on the screen when you press the Dia-
gnosis, Start-up, Machine data and PLC MD softkeys.
Note A brief description of the PLC configuration and PLC machine data appears on
the screen when you press the info key.
Fig. 5.6
Explanation In this display you configure the current assignments (control panel available,
address, TT machine, etc.) for the 1st and 2nd machine control panel. The con-
tents of the display fields show the settings in the following machine data.
1st machine control panel (MCP)
S
5–18
Machine
data
PLC MD
Available:
The 1st machine control panel is displayed as available when PLC MD 6066.0
(machine control panel available) is set.
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
09.95
Diagnosis
Start-up
SINUMERIK 840C (IA)