Siemens SINUMERIK 840C Installation Instructions Manual page 388

09.01
3216*-
Tol. band for synchr. "fine" 2nd - 8th parameter set
3240*
Default value
40
These MD have the same meaning as MD 1436*, see also "Functional Descriptions:
Parameter set switchover".
3244*-
Tol. band for synchr. "coarse" 2nd - 8th parameter set
3268*
Default value
100
These MD have the same meaning as MD 1440*, see also "Functional Descriptions:
Parameter set switchover".
3272*-
Emergency retraction threshold 2nd - 8th parameter
3296*
Default value
400
These MD have the same meaning as MD 1444*, see also "Functional Descriptions:
Parameter set switchover".
3300*-
Time const., set speed link path 1st to 8th par. set
3328*
Default value
0
See also "Functional Descriptions: Parameter set switchover". These machine data are active
only with gear interpolation.
3332*-
3360*
Default value
0
See description of function Parameter set switchover and jerk limitation Section 10.4.1.5.
3364*-
3388*
Default value
0
See description of function Parameter set switchover.
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
6 NC Machine Data (NC MD), NC Setting Data (NC SD)
as from SW 4
Lower input limit Upper input limit
0 99 999 999 (SW 5.4
and higher)
as from SW 4
Lower input limit Upper input limit
0 99 999 999 (SW5.4
and higher)
as from SW 4
Lower input limit Upper input limit
0 99 999 999 (SW5.4
and higher)
as from SW 4
Lower input limit Upper input limit
0
Maximum jerk (as from SW 6)
1st-8th PaSe
Lower input limit Upper input limit
0 99 000 000
Acceleration (as from SW 6)
2nd-8th PaSe
Lower input limit Upper input limit
6FC5197- AA50
6.9 MDs for parameter set switchover
Units
16 000
1 unit (MS)
Units
16 000
1 unit (MS)
Units
16 000
1 unit (MS)
Units
16 000 0.1 ms
Units
0,1 ms/s
Units
Active on
RESET
Active on
RESET
Active on
RESET
Active on
NC Stop
Active on
NC Stop
3
Active on
NC Stop
6–203