General Machine Data (General Data) - Siemens SINUMERIK 840C Installation Instructions Manual

6 NC Machine Data (NC MD), NC Setting Data (NC SD)

6.2 General machine data (general data)

6.2 General machine data (general data)
1
Default value
500
V (m/min)
Velocity behind SW pre-limit switch
Position of SW pre-limit switch
Velocity diagram on crossing the software limit switch with circular interpolation
Note:
NC MD 1 has no effect when 0 is entered in NC MD 1100*.
See also NC MD 2240-2371, NC MD 1100* and NC MD 5003.7.
6–6
Velocity behind pre-limit switch
Lower input limit Upper input limit
+0 100 000
NC MD 1100*
Position of SW limit switch
NC MD 2240-2371
©
Siemens AG 1992 All Rights Reserved
03.95
Active on
NC Stop
Units
1 000 units/
min (IS)
Braking characteristic
s (mm)
Axis stop point
6FC5197- AA50
SINUMERIK 840C (IA)