Siemens SINUMERIK 840C Installation Instructions Manual page 211

6 NC Machine Data (NC MD), NC Setting Data (NC SD)
6.2 General machine data (general data)
335
Minimum reduction factor (as from SW 6)
Default value
100
The minimum reduction factor is entered as a percentage in the general machine data.
The actual path velocity is adapted to the new set path velocity by way of the actual path
acceleration.
336
Default value
0
The velocity increase factor is the value in percent per IP cycle by which the reduction factor
is again increased to 100% after failure to reach the hysteresis threshold of the following axis
velocity.
337 2nd MCS offset in X coordinates (as from SW 6)
Default value
0
Note:
For further information see description of the function collision monitoring.
338
2nd MCS offset in Y coordinates (as from SW 6)
Default value
0
Note:
For further information see description of the function collision monitoring.
6–26
Lower input limit
0
Velocity increase factor (as from SW 6)
Lower input limit
0
Lower input limit
0
Lower input limit
0
©
Siemens AG 1992 All Rights Reserved
Upper input limit
100
Upper input limit
10 000 0.01·%/T
Upper input limit
99 999 999
Upper input limit
99 999 999
SINUMERIK 840C (IA)
07.97
Active
at once
Units
%
Active on
at once
Units
IPO
POWER ON
Units
MS
POWER ON
Units
MS
6FC5197- AA50