Siemens SINUMERIK 840C Installation Instructions Manual page 409

Siemens computer drive installation instructions
Hide thumbs Also See for SINUMERIK 840C:
Table of Contents

Advertisement

6 NC Machine Data (NC MD), NC Setting Data (NC SD)
6.12.1 NC setting data (NC SD)
The setting data can be written from a part program under "Program control" using the
command @410 or from the PLC. A larger value can be written as the available block memory.
The NC however still predecodes no more than the stated number of blocks. If the setting data
is reduced when already more than the defined number of blocks has been predecoded, no
more blocks are predecoded until this number is reached.
Limitation is especially useful when a program is being run in (single block processing).
206*
Actual number of predecoded blocks (as from SW 5)
Default value
The number of blocks actually predecoded by the NC can be read in setting data 206*. The
inserted blocks in the block preparation chain are also counted.
The value is displayed under "Program control" but can also be read in the part program
(@310) by the PLC. The user can use this command to control predecoding from the PLC
(see also function "Control of predecoding G171/G172").
The value must not be overwritten. It is constantly updated by the NC when the part program
is active.
Note:
The actual number of predecoded blocks never reaches the value set in the memory
configuration because up to 20 buffers are used for internal memory management.
300*
Default value
– 99 999.999
304*
Default value
+ 99999.999
With working are limitation, the range of travel can be limited in automatic, and/or JOG mode
(in addition to software limit switches). The axes are displayed for each mode group. The
working area limitation can be altered in the program with G25/26.
Working are limitation has no effect in the "Reference point approach mode".
6–224
Lower input limit
Upper input limit
Minimum working area limitation
Lower input limit
Upper input limit
– 99 999.999
+ 99 999.999
Maximum working area limitation
Lower input limit
Upper input limit
– 99 999.999
+ 99 999.999
©
Siemens AG 1992 All Rights Reserved
08.96
Active on
Units
Blocks
Active on
Units
mm or inches
Active on
Units
mm or inches
6FC5197- AA50
SINUMERIK 840C (IA)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Simodrive 611-d

Table of Contents