Adding A 1-Axis Fdd Module (As From Sw 3) - Siemens SINUMERIK 840C Installation Instructions Manual

Siemens computer drive installation instructions
Hide thumbs Also See for SINUMERIK 840C:
Table of Contents

Advertisement

5 Machine Data Dialog (MDD – as from SW 3)

5.9.2 Adding a 1-axis FDD module (as from SW 3)

5.9.2
Adding a 1-axis FDD module (as from SW 3)
Specifications
Module slots:
(Installation location) Slot 2:
Entering the
Enter the additional 1 axis FDD module for slot 2 (installation location) in the
drive configuration
drive configuration display. Select the actual module type with Select module
softkey. Confirm these settings with the Accept Conf + NCKP0 softkey.
Fig. 5.18
Motor selection
Select the actual motor type with the Enter motor softkey. Confirm this setting
with the Accept all + NCKP0 softkey.
Notes
Please make sure that you enter NC MD 3840 and 2000 correctly (assign).
The drive numbers of drives already installed must not be changed, i.e. a new
drive must be given a new drive number.
5–44
Slot 1:
MSD module
free
Slot 3:
free
Slot 4:
2 axis FDD module
Slot 6:
1 axis FDD module
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
09.95
SINUMERIK 840C (IA)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Simodrive 611-d

Table of Contents