Siemens SINUMERIK 840C Installation Instructions Manual page 568

04.96
1657
Default value
0000 0000
Output of monitoring function display value. This machine data displays the content of the
address resulting from the segment (MD 1655) and the offset (MD 1656).
1658
Default value
0000 0000
A 24-bit value can be entered in this machine data. The value is written in the monitoring
function to the address specified by the segment (MD 1655) and the offset (MD 1656). The
value is not written until machine data "Value acceptance monitor" (MD 1659) has been set
to 1.
Caution:
This machine data is relevant only for Siemens-internal purposes and must not be altered.
1659
Default value
0
This machine data writes the value (MD 1658) to the addressed memory location (MD 1655,
MD 1656) if the value "1" has been entered to initiate the write operation. On completion of
the write operation, the machine data is automatically reset to "0".
Caution:
This machine data is relevant only for Siemens-internal purposes and must not be altered.
1660
Default value
1.0
Input of a setpoint frequency (electrical) for the drive in voltage-controlled V/f mode. The +
or – sign corresponds to the appropriate direction of rotation of the motor.
Note:
• This machine data is only used for diagnostics and may only be used or applied by trained
service personnel.
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
Value display monitor
Lower output limit
0000 0000
Value input monitor
Lower input limit
0000 0000
Value acceptance monitor
Lower input limit
0
Motor frequency V/f mode (SW 4.4 only)
Lower input limit
-10000.0
6FC5197- AA50
7 Drive Machine Data (SIMODRIVE Drive MD)
7.3.2 Drive MD (data description)
Upper output limit
FFFF FFFF
Upper input limit
FFFF FFFF
Upper input limit
1
Upper input limit
10000.0
Active
at once
Units
Hex
Active
at once
Units
Hex
Active
at once
Units
–
Active
at once
Units
Hz
7–153