2Nd Level: Configuring The Individual Machine Data Areas - Siemens SINUMERIK 840C Installation Instructions Manual

5 Machine Data Dialog (MDD – as from SW 3)
5.8.2 2nd level: Configuring the individual machine data areas (as from SW 3)
In the case of "Save all" the NQEC parameterization including the measured val-
ues from the NCK/servo are read out and stored in ASCII files under the selected
name.
In the case of "Load all", the selected NQEC ASCII files are read in and stored as
boot files. A backup mechanism which is similar to that of TEA2-Load-all is imple-
mented which is able to recover the NQEC boot files automatically on a power
failure, emergency stop, if the hard disk is full or the abort key has been operated
etc.
New alarms for this function: 165051 to 165054.
5.8.2 2nd level: Configuring the individual
machine data areas (SW 3 and higher)
Drive machine data (TEA3)
NC machine data (TEA1)
General
NC MD
Memory
config.
PLC machine data (TEA2)
I/O device
setting
Cycle machine data (TEA4)
Central
cycle MD
Interpolation compensation machine data (IKA1 – IKA3)
IKA con-
figuration
Explanation
On the 2nd level the file functions refer to the data of the individual machine data
areas. If the same file names are assigned to data records in different areas, they
appear on the first level (machine configuration) under one data selector and can
be loaded together from there.
5–34
Axis
(FDD)
Geometry Channel Axis
motion
Alarms PLC basic User
messages data MD
Chan. dep.
cycle MD
IKA curve IKA error
pointer points
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
Spindle File
(MSD) functions
Spindle Gearbox File
interpol. functions
Tool Computer File
manage- link functions
ment
File
functions
File
functions
SINUMERIK 840C (IA)
09.95
"