Siemens SINUMERIK 840C Installation Instructions Manual page 772

01.99
39) SK "Exit general reset mode"
40) SK "Machine data"
41) SK "Drive MD"
42) SK "File functions"
43) Place cursor on required file
44) SK "Loading from disk"
45) Set "Config." area
via toggle switch
46) SK "Loading start"
47) After completion of loading,
48) Vertical SK
Accept "Conf" + "NCK PO"
49) Machine display faded in
50) Press area switchover key
51) SK "Diagnosis"
52) SK "File function"
53) Place cursor on required file
© Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
11.1.7 Loading from hard disk (control startup with user data)
Loading drive user data TEA3
Warning:
Digital drives must be switched in!
!!!Data transfer from PC to NC in progress!!!
press "Recall"
3
6FC5197- AA50
11 Data Backup/CPU Replacement
Boot file generated
11–13