Siemens SINUMERIK 840C Installation Instructions Manual page 43

2 General Reset and Standard Start-Up
2.8 Standard installation short version (up to SW 2)
When the softkeys, DIAGNOSIS, NC DIAGNOSIS, NC START-UP and ENTER
PASSWORD have been pressed, the following display appears:
Fig. 2.3
The password for the NCK area is set in machine data 11. The default value 0
corresponds to password
Any other value defined in machine data 11 must have four digits.
The value is accepted with the INPUT key and the text "ENTER PASSWORD"
disappears.
The password is reset with the "Lock password" softkey.
LOCK
If the password has not been set correctly, the message "Password incorrect" ap-
PASSWORD
pears.
2-12
MACHINE PARAMETER PROGRAMM.
JOG PROGRAM RESET
NC alarms
Enter password
PLC CYCLE
NC
MA. DAT MA. DAT. MA. DAT.
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
SERVICES
ENTER LOCK
PASSWORD PASSWORD RESET MODE
+ + + .
09.95
DIAGNOSIS
16:38
M. No. :1
Chann :1
****
GENERAL
SINUMERIK 840C (IA)