Siemens SINUMERIK 840C Installation Instructions Manual page 413

6 NC Machine Data (NC MD), NC Setting Data (NC SD)
6.12.1 NC setting data (NC SD)
Axial bits
SD MD 7
560*
Bit 2 The scale factor (G51) is active during machining.
Bit 1 Override switch for rapid traverse no longer active in the axis in question.
Bit 0 Override switch for feedrate no longer active in the axis in question.
SD 7
564*
Evaluation of handwheel pulses (applies to both handwheels) per axis
Bit 0=1
Bit 1=1 10 increments per handwheel pulse (display resolution)
Bit 2=1 100
Bit 3=1 1000
Bit 4=1 10000
Spindle converter setting data
SD 7
600*
to
625*
The setting data are stored as follows in binary format.
SD 600* 1st progr. spindle channel-specific
SD 604* 2nd progr. spindle channel-specific
SD 608* 3rd progr. spindle channel-specific
SD 612* spindle conversion list on/off (1=on, 0=off)
These setting data can be altered via @311, @312, @411, @412 / PLC / RS 232 C (V24).
The spindle converter only operates in the automatic, teach-in and MDA modes but not with
overstore.
The automatic basic display does not show that the spindle converter is active.
Note:
See Functional Description for detailed description.
6–228
Bit No.
6 5 4
Bit No.
6 5 4
10000
1 increment per handwheel pulse (display resolution)
"..."
"..."
"..."
Bit No.
6 5 4
Spindle converter
SD 602*
SD 606*
SD 610*
©
Siemens AG 1992 All Rights Reserved
3 2 1
Scale factor Rapid
active on override not
machine active
3 2 1
Increments per handwheel pulse
1000 100 10
3 2 1
1st real spindle channel-specific
2nd real spindle channel-specific
3rd real spindle channel-specific
6FC5197- AA50
SINUMERIK 840C (IA)
07.97
0
Feedrate
override not
active
0
1
0