Siemens SINUMERIK 840C Installation Instructions Manual page 295

6 NC Machine Data (NC MD), NC Setting Data (NC SD)
6.6.1 General MD bits (general bits)
NC MD 7
5053
Default value: 0
Bit 0 Channel-specific axis and spindle display (as from SW 5)
Bit 0=1 Display of the axes according to the setting in MD 9000 ... 9099,
display of the spindles according to setting of the MD 9100 ... 9139
Bit 0=0 Display of the axes and spindles as before (mode-group-specific)
Bit 1 Bit 1=1 If this bit is active, all axes are displayed in the machine basic display,
whatever mode group they are assigned to. Whether individual axes are
displayed or not can be set in channel-specific bits 900*.
Note:
The machine data bit is independent of the option multichannel display. This means that the
user can set precisely those axes and spindles he wishes to display even in single-channel
display (no multichannel display option). No change to displays already created is required. It is
only important to make sure that MD 9000 ... 9139 are set for channel-specific display of the
axes and spindles because the standard setting is 0. This means no display.
_______
1) As from SW 5
6–110
Bit No.
6 5 4
©
Siemens AG 1992 All Rights Reserved
3 2 1
Axis display
for all mode
groups (as
from SW 6)
6FC5197- AA50
SINUMERIK 840C (IA)
07.97
0
Channel-
spec. axis
and spindle
display 1)