Siemens SINUMERIK 840C Installation Instructions Manual page 584

09.95
10100-
10114
1)
10119
Default value
0
The "Module order code" machine data contains the selected module in the form of a decimal
code number. In the case of two-axis modules, the data contains two sets of information.
Machine data 10100 to 10114 are assigned to physical addresses 1 to 15.
10200-
10214
1)
10229
Default value
0000
The "Power section code" machine data contains the required or used amperages for the
selected module according to the hexadecimal code number (see also MD 1106). In the case
of two-axis modules, the data contains two sets of information. Machine data 10200 to 10214
are assigned to physical addresses 1 to 15.
10900
Default value
–
10901
Default value
–
10902
Default value
–
10903
Default value
–
10903.0 Mixed I/O
10903.1 DCM
1) As from SW 5
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
7.4.3 Diagnosis/service MD (data description - as from SW 3)
Module order code (as from SW 4)
Lower output limit
0
Power section code (as from SW 4)
Lower output limit
0000
Data version (as from SW 4)
Lower output limit
–
Firmware version (as from SW 4)
Lower output limit
–
Firmware data (as from SW 4)
Lower output limit
–
Hardware configuration (as from SW 4)
Lower output limit
–
6FC5197- AA50
7 Drive Machine Data (SIMODRIVE Drive MD)
Upper output limit
65535
Upper output limit
FFFF
Upper output limit
–
Upper output limit
–
Upper output limit
–
Upper output limit
–
Active on
Power on
Units
-
Active on
Power on
Units
Hex
Active
Units
–
Active
Units
–
Active
Units
–
Active
Units
–
7–169