Siemens SINUMERIK 840C Installation Instructions Manual page 919

Siemens computer drive installation instructions
Hide thumbs Also See for SINUMERIK 840C:
Table of Contents

Advertisement

12 Functional Descriptions
12.18.11 GI monitors
n
FA
approx.20%
approx.10% control reserve
Reaction time
Characteristic of the velocity setpoint with the characteristic rising above and falling below the warning threshold
In NC channels where axes are traversed which are enabled for velocity/acceleration limitation,
the acceleration in the path is stopped as follows:
Path set velocity = path actual velocity
The acceleration of released spindles is stopped if:
Set speed = actual speed
Due to non-linear movements of the leading axes (circle, Spline, IKA, transformation, etc.), the
velocity of the following axis may increase despite an acceleration stop of the leading axes.
In order to reduce the path velocity, the actual path set velocity is evaluated with a reduction
factor (MD 335 "Minimum reduction factor with velocity limitation following axis warning
threshold"), similar to an override. The channel thus calculates the path set velocity as follows:
V
=
path_set
Vpath_set
In doing so, the interpolation grouping of the axes involved in the path, as well as the active
links, remain unchanged.
If the following axis velocity falls again below the hysteresis threshold, the request for
velocity/acceleration limitation is reset for all axes and spindles of the mode group. The
reduction factor in the NC channels is reset to 100%.
In order to avoid oscillations within the range of the hysteresis threshold and to bridge
machining steps temporarily resulting in an unfavorable velocity/acceleration override, the
increase of the reduction factor can be slowed down by means of MD 336 "Velocity increase
factor".
12–144
· MD335
© Siemens AG 1992 All Rights Reserved
MD 264*
Drive error threshold
MD 268*
max.setpoint (IPO STOP)
MD 1736*-1764*
Alarm limit velocity:
1st PaSa - 8thPaSa (param. set)
MD 1448*
Warning threshold
n
and a
max
max
7/8 · MD1448*
Hysteresis threshold
PLC interface signal:
Vel. warning thresh. reached
internal:
Velocity limitation approached
6FC5197- AA50
SINUMERIK 840C (IA)
09.01

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Simodrive 611-d

Table of Contents