Siemens SINUMERIK 840C Installation Instructions Manual page 69

Siemens computer drive installation instructions
Hide thumbs Also See for SINUMERIK 840C:
Table of Contents

Advertisement

4 MMC Area Diagnosis
4.1.4 Selection of the diagnosis area
Display NCK software version
NC info
For description see NC service in this section.
NC service
The displays are used for debugging incorrect programs. The status display is
PLC
used to show PLC data (e.g.: I, Q, ...).
service
For description see Section 3, Start-up PLC
Subsection ISTACK, detailed error coding, PLC status
For description see under subsection: Drive service displays for spindle and axis.
Drive MSD/
FDD
For OEM applications
Exit points
A
Start-up
Fig. 4.5
In SW4 the logbook contains the current version numbers of the software compo-
Logbook
nents installed on the hard disk.
As from SW5, the first line also indicates the sum software version.
Caution: As from SW4, no entries must be made in the logbook, because it would
be overwritten on every software upgrade.
Up to and including SW3 information can be placed in the logbook which is im-
portant for service on the control.
4–6
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
09.95
SINUMERIK 840C (IA)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Simodrive 611-d

Table of Contents