Siemens SINUMERIK 840C Installation Instructions Manual page 126

09.95
You can create the PCF file with the ASCII editor, configuring is described in In-
terface Description Part 1. The ASCII editor is described in the Operator's Guide.
You store the file onto the hard disk with the SAVE softkey.
SAVE
Creating and editing PCF files in the programming area (NCK area)
Press the area switchover key.
Press programming key.
Programm.
Press the edit NC softkey.
EDIT
NC
Enter the required program with the identifier "%PCF..." in the input line and ac-
SELECT
cept with the PROGRAMMING softkey.
PROGRAM
The DIN editor is displayed. Please refer to the Interface Description Part 1, Si-
gnals, for notes on configuring. The DIN editor is described in the Operator's
Guide.
Saving the PCF file Enter passwords in the NCK and MMC area.
Select the DIAGNOSIS/START-UP/PLC DATA area with the cursor and the input
key and keep pressing the keys until you reach the directory of language files,
select and accept the required language.
Press the SAVE softkey. A dialog screen form with a toggle field and 4 input
fields appears.
SAVE
You select the PCF data type with the horizontal cursor keys in the PLC
SOURCE toggle field. The input fields are filled in according to the entries in the
NCK memory.
You initiate transmission with the START softkey. The following message ap-
pears:
START
If a PCF file of the same name already exists you are asked whether you wish to
overwrite it:
The PC data are overwritten when you press the softkey OK.
OK
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
SINUMERIK 840C (IA)
When you have completed editing, you must load the crea-
ted PCF file from the NCK memory in the DIAGNOSIS area
to the hard disk, as data are lost when the control is
switche doff.
!!! Transmission from NC to PC active !!!
PC data exists. Overwrite?
4 MMC Area Diagnosis
4.8.3 PCF files (up to SW 2)
4–63