Siemens SINUMERIK 840C Installation Instructions Manual page 588

09.95
Bit 10 - SW 4 Command variable
Bits 11-12 (Bit 11:) Master-slave operation setpoint
Bit 13 Travel against fixed stop setpoint
Bit 14 C axis mode setpoint
Bit 15 Sign of life
11006
Default value
–
This machine data contains the warnings of a digital drive. It is stored on an axis-specific basis
at the interface between the SERVO and the 611D.
Bit 0 DC link (off ˆ = DC link fault)
Bit 1 - SW 4 DC link voltage emergency retraction ( MD 1634)
Bit 2 - SW 4 Emergency retraction/generator mode active
Bit 3 - SW 4 Generator speed < minimum speed
Bits 4-13 Assigned to or reserved for internal system functions
Bit 14 Motor temperature warning
Bit 15 Heat sink temperature warning
11007
Default value
–
This machine data contains the warnings of a digital drive. The machine data is stored on an
axis-specific basis at the interface between the SERVO and the 611D. For bits 6 to 15 there is
no evaluation or connection to the PLC.
Bit 0 - SW 3 Programmable message 1
Bit 0 - SW 4 Ramp-up completed
Bit 1 - SW 3 Programmable message 2
Bit 1 - SW 4 I M I< M
d dx
Bit 2 - SW 3 Programmable message 3
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
7.4.3 Diagnosis/service MD (data description - as from SW 3)
Status class 2
Lower output limit Upper output limit
0000
Status class 3
Lower output limit Upper output limit
0000
6FC5197- AA50
7 Drive Machine Data (SIMODRIVE Drive MD)
0 : torque
1 : speed
0 : off
1 : on
after ramp-up
of 611D link
Units
FFFF Hex
0 : off
1 : on
0 : on
1 : off
0 : off
1 : on
after ramp-up
of 611D link
Units
FFFF Hex
0 : off
1 : on
Active
Active
7–173