Practical Example For User Adaptation List Display - Siemens SINUMERIK 840C Installation Instructions Manual

09.95
List contents: The texts for all data are stored in the text lists.
Text lists
Examples: 2040
2080
5600.0
5600.2
List contents: The data type (L = long, C = 8 bits, S = short, etc.) and the display format, any
Semantic lists special treatment and input limits are stored in the semantics lists.
Examples: Data
160
164
168
208
The information under "Treatment" is interpreted as follows:
Explanations for all the data that appear in the information display (key ¼) can
List contents: Info lists
be stored in the information lists.
Example: 2040

Practical example for user adaptation list display

5.10.2
Problem "PLC machine data 2007 is supplied with the text "Number of assigned maga-
zine" and with input limits 0 to 4
The user wishes to change this text to the following:
"Number of assigned tool turret"
and the input limits to 1 to 99.
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
SINUMERIK 840C (IA)
"Exact stop limit coarse"
"Exact stop limit fine"
"No measuring circuit monitoring"
"Rounding to whole/half degrees"
Type Treatment
L
L
L "0.0625 5.2 2"
L
00 1:1 - representation
05 bzw. 07 special treatment or.
-representation
"0.0625 5.2 2"
Unit no.
(the units are in text list tea1unit.106)
5 places, of which 2 are behind the decimal point
Factor for display
"This data is not active until Power On".
5 Machine Data Dialog (MDD – as from SW 3)
5.10.2 Practical example for user adaptation list display
Input limits
05
00 ! (write-protected)
72 1.99999999
2.32
5–53