Axis Installation (Simplified, Up To Sw 2 Only) - Siemens SINUMERIK 840C Installation Instructions Manual

2 General Reset and Standard Start-Up

2.13 Axis installation (simplified, up to SW 2 only)

2.13 Axis installation (simplified, up to SW 2 only)
START
JOG mode
Axis traversing move-
ment (direction key)
Feed
hold?
Alarm?
Rapid traverse
Alarm?
1000 mm
set movement=1000 mm
at machine?
No
All axes
traversed?
Perform drift compen-
sation (NC-MD 272*)
END
2-18
Check the enables
Yes
No
Yes
No
Yes
No
No
Yes
Yes
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
Check of PLC
program
Yes
No
Feed enable?
Position control
direction OK?
(s. Sect. 5, check MDs)
Check MDs: 256*,
260*, 268*, 276*, 280*,
264*, 364*, 368*
NC MD 364*, 368*,
1800*
SINUMERIK 840C (IA)
09.95