Siemens SINUMERIK 840C Installation Instructions Manual page 303

6 NC Machine Data (NC MD), NC Setting Data (NC SD)
6.6.1 General MD bits (general bits)
NC MD 7
5156
to
5182
Default value: All bits 0
The definition of this coupled axis combination defines which coupled axis pairings form a
coupled axis combination and how the coupled motion is performed (coupled motion in the
same direction or opposite directions).
The 9 possible coupled axis combinations are programmed with G151 to G159. Each coupled
axis combination is defined with 3 NC MDs corresponding to the 9 coupled axis pairings (12
times 2 bits).
Active: RESET
See also NC MD 876 - 899 and the Programming Guide.
1st coupled axis combination
2nd coupled axis combination
3rd coupled axis combination
4th coupled axis combination
5th coupled axis combination
6th coupled axis combination
7th coupled axis combination
8th coupled axis combination
9th coupled axis combination
6–118
Bit No.
6 5 4
Coupled motion combination
Programming
G151
G152
G153
G154
G155
G156
G157
G158
G159
©
Siemens AG 1992 All Rights Reserved
3 2 1
NC MD
5156 to 5158
5159 to 5161
5162 to 5164
5165 to 5167
5168 to 5170
5171 to 5173
5174 to 5176
5177 to 5179
5180 to 5182
6FC5197- AA50
SINUMERIK 840C (IA)
12.93
0