Siemens SINUMERIK 840C Installation Instructions Manual page 664

Siemens computer drive installation instructions

Hide thumbs Also See for SINUMERIK 840C:

Table of Contents

The displayed measurement results can be stored as a file on the MMC by selecting

softkey File functions.

Data output of

Data can be output on an external PC via the V24 interface and

circularity test

by means of commands in the "Services" menu. The extensions for "Services"

measurement results

required for this purpose are listed in the requirements to other areas. Data can

therefore be output in PC format with the aid of the "PC-IN" program. Within this

program, it is possible to re-convert the data back to the original ASCII format

with software version 3.0 and higher.

Measurement results can also be written to a file using the hardcopy function and

output by means of "Services" functions.

You can switch to graphic representation of the contour with this softkey.

The contour is shown without any distortion if the value 0 is entered in the field

"Resolution". If suitable radius and feedrate values are entered, other contours

can also be displayed.

Radius and feedrate represent the input parameters required for setting the mea-

suring duration and the radius is used to define the form of graphic representa-

Storage and output of the measuring results are the same as described for the

circularity test display in Section 9.5.2.

SINUMERIK 840C (IA)

9 Drive Servo Start-Up Application (as from SW 3)

9.5.2 Circularity test (option – SW 4)

Show Quick Links

Table of Contents

Simodrive 611-d