Selection Of Measured Signal - Siemens SINUMERIK 840C Installation Instructions Manual

9 Drive Servo Start-Up Application (as from SW 3)

9.6.1 Selection of measured signal

9.6.1 Selection of measured signal
You can select lists containing a selection of signals with this vertical softkey (see
Selection
Fig. 9.35).
meas. signal
Explanation Signals are selected or deselected with the cursor hardkeys and softkeys ok and
Abort. The page-up and page-down hardkeys can be used to scroll in this list.
SERVO signals for Following error
axes/spindles Absolute setpoint
Absolute actual value
Speed setpoint (0.01 %)
Part actual value (active)
Part setpoint
Synchronism error
SERVO signals for axes Contour deviation
Abs. compensation value
SERVO signals for Speed setpoint (present)
spindles Speed setpoint (RFG output)
Speed actual value
Special SERVO signals Part actual value 1st MS
Part actual value 2nd MS
Following error (IPO cycle)
Absolute value modulo
Part setpoint (FIPO input)
Absolute position setpoint (PC)
Part setpoint (FIPO output)
Part compensation value FIPO output
Part compensation value FIPO input
Leading axis total actual value link
Leading axis total all leading axes
Leading axis total active
Angular offset (mech. coupling)
Position setpoint (PC cycle)
Absolute actual value (PC cycle)
Quadrant error
Quadrant error plane
Torque compensation controller output (SW 5)
Setpoint torque compensation control (SW 5)
611D signals in position Current actual value
controller cycle Power
Torque
Torque (delta)
Speed actual value
Capacity utilization in %
NCK signals Axial feedrate
(as from SW 5) Path feedrate
Distance-to-go path
Distance-to-go axis
Number of predecoded blocks
Capacity utilization
Set position before transformation
Path feedrate before transformation
IKA input A
IKA input B
IKA output
9–66
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
09.95
SINUMERIK 840C (IA)