Resetting An Interface To Its Factory Default State; Enabling A Physical Interface - Dell S3048-ON Configuration Manual

interface GigabitEthernet 2/6
no ip address
shutdown
!
interface GigabitEthernet 2/7
no ip address
shutdown
!
interface GigabitEthernet 2/8
no ip address
shutdown
!
interface GigabitEthernet 2/9
no ip address
shutdown

Resetting an Interface to its Factory Default State

You can reset the configurations applied on an interface to its factory default state. To reset the configuration, perform the following steps:
1 View the configurations applied on an interface.
INTERFACE mode
show config
Dell(conf-if-gi-1/5)#show config
!
interface GigabitEthernet 1/5
no ip address
portmode hybrid
switchport
rate-interval 8
mac learning-limit 10 no-station-move
no shutdown
2 Reset an interface to its factory default state.
CONFIGURATION mode
default interface interface-type]
Dell(conf)#default interface gigabitethernet 1/5
3 Verify the configuration.
INTERFACE mode
show config
Dell(conf-if-gi-1/5)#show config
!
interface GigabitEthernet 1/5
no ip address
shutdown
All the applied configurations are removed and the interface is set to the factory default state.

Enabling a Physical Interface

After determining the type of physical interfaces available, to enable and configure the interfaces, enter INTERFACE mode by using the
interface interface command.
1 Enter the keyword interface then the type of interface and slot/port information.
CONFIGURATION mode
Interfaces 319