Resetting An Interface To Its Factory Default State - Dell S6100 Configuration Manual

Hide thumbs Also See for S6100:

Table of Contents

TenGigabitEthernet 1/1/9/4

fortyGigE 1/1/11

fortyGigE 1/1/12

fortyGigE 1/1/13

fortyGigE 1/1/14

TenGigabitEthernet 1/1/15/1

TenGigabitEthernet 1/1/15/2

TenGigabitEthernet 1/1/15/3

TenGigabitEthernet 1/1/15/4

fortyGigE 1/2/1

fortyGigE 1/2/2

To view only configured interfaces, use the show interfaces configured command in the EXEC Privilege mode.

To determine which physical interfaces are available, use the show running-config command in EXEC mode. This command displays

all physical interfaces available on the system.

Dell#show running-config

[output truncated]

interface hundredGigE 1/1/1

no ip address

interface hundredGigE 1/1/2

no ip address

interface hundredGigE 1/1/3

no ip address

interface hundredGigE 1/1/4

no ip address

Resetting an Interface to its Factory Default State

You can reset the configurations applied on an interface to its factory default state. To reset the configuration, perform the following steps:

View the configurations applied on an interface.

INTERFACE mode

Dell(conf-if-te-1/1/5/1)#show config

interface TenGigabitEthernet 1/1/5/1

no ip address

portmode hybrid

rate-interval 8

mac learning-limit 10 no-station-move

Reset an interface to its factory default state.

CONFIGURATION mode

default interface interface-type]

Dell(conf)#default interface tengigabitethernet 1/1/5/1

Verify the configuration.

INTERFACE mode