O: Operator Related Settings; O1: Digital Operator Display Selection - YASKAWA FSDrive-MV1000 Parameter Manual

2.10 o: Operator Related Settings

These parameters are for controlling the various functions, features, and display of the digital operator.

◆ o1: Digital Operator Display Selection

These parameters determine how data appears on the operator display.
o1-01: Drive Mode Unit Monitor Selection
■
When the drive is powered up, the monitor selected in parameter o1-02 appears first on the display. If o1-02 is set to 5,
o1-01 can be used to change the content of this monitor.
When using the digital operator, pressing the up arrow key will display the following data: speed reference → rotational
direction → output speed → output current → o1-01 selection.
Parameter o1-01 lets the user select the content of the last monitor in this sequence. There is no effect like this on an LCD
operator.
No.
o1-01 Drive Mode Display Item Selection
<1> U2- and U3- parameters cannot be selected
o1-02: User Monitor Selection after Power Up
■
Selects which monitor parameter is displayed upon power up. This is done by entering the 1
monitors are not available in some control modes. Refer to
No.
o1-02 User Monitor Selection after Power Up
Setting 1: Frequency reference (U1-01)
Setting 2: Motor direction
Setting 3: Output frequency (U1-02)
Setting 4: Output current (U1-03)
Setting 5: User-selected monitor (set by o1-01)
o1-03: Digital Operator Display Selection
■
Sets the units used to display the frequency reference and monitor values. Set o1-03 to 3 to select user-set units, then set
details in parameters o1-10 and o1-11.
No.
o1-03 Frequency Reference Setting/Display Unit 0 to 3
<1> For details on the default settings, refer to
Setting 0: 0.01 Hz units
Setting 1: 0.01% units (100% = max. output frequency)
Setting 2: r/min units (calculated by the max. output frequency and the no. of motor poles)
Setting 3: User-set units (use o1-10, o1-11)
Set the value use for the maximum frequency reference in o1-10. The placement of the decimal point in this number
should be set to o1-11.
For example, to have the maximum output frequency displayed as "100.00", set o1-10 = 1000 and o1-11 = 2 (i.e., 1000
with 2 decimal points).
YASKAWA ELECTRIC EZZ010930 FSDrive-MV1000 Parameter Guide
Name
104 to 699
U1-04 (Control Mode) to U6-99 (Option
Monitor 20)
Name
1 to 5
Name
Control Mode Dependent Parameter Default Values on page
2.10 o: Operator Related Settings
Setting Range
<1>
U: Monitors on page 70
Setting Range
Setting Range
Default
106 (U1-06)
part of U1-
for a list of monitors.
Default
1
Default
Determined by A1-02
<1>
79.
. Certain
221