Motorola WiNG 5 System Reference Manual page 86

5 - 26 WiNG 5 Access Point System Reference Guide
7. Set the following port channel Properties:
Description
Admin Status
Speed
Figure 5-13 Port Channels - Basic Configuration screen
Enter a brief description for the port channel (64 characters maximum). The
description should reflect the port channel's intended function.
Select the Enabled radio button to define this port channel as active to the
controller profile it supports. Select the Disabled radio button to disable this
port channel configuration within the profile. It can be activated at any future
time when needed. The default setting is disabled.
Select the speed at which the port channel can receive and transmit the data.
Select either 10 Mbps, 100 Mbps, 1000 Mbps. Select either of these options
to establish a 10, 100 or 1000 Mbps data transfer rate for the selected half
duplex or full duplex transmission over the port. These options are not
available if Auto is selected. Select Automatic to enable the port channel to
automatically exchange information about data transmission speed and duplex
capabilities. Auto negotiation is helpful when in an environment where
different devices are connected and disconnected on a regular basis.
Automatic is the default setting.