Motorola WiNG 5 System Reference Manual page 207

Weightage given to
Client Count
Weightage given to
Throughput
Max. 5GHz Load
Difference Considered
Equal
Min. Value to Trigger
5GHz Channel Balancing
Weightage given to
Client Count
Weightage given to
Throughput
10. Set the following AP Load Balancing
Min Value to Trigger
Load Balancing
Max. AP Load Difference
Considered Equal
Weightage given to
Client Count
Use the spinner control to assign a weight (between 0 - 100%) the access
point uses to prioritize 2.4GHz radio client count in the 2.4GHz radio load
calculation. Assign this value higher this 2.4GHz radio is intended to
support numerous clients and their throughput is secondary to maintaining
association. The default setting is 90%.
Use the spinner control to assign a weight (between 0 - 100%) the access
point uses to prioritize 2.4 radio throughput in the access point load
calculation. Assign this value higher if throughput and radio performance
are considered mission critical and more important than a high client
connection count. The default setting is 10%.
Use the spinner control to set a value (between 0 - 100) considered an
adequate discrepancy (or deviation) when comparing access point 5GHz
radio load balances. The default setting is 1%. Thus, using a default setting
of 10% means 10% is considered inconsequential when comparing access
point radio load balances exclusively on the 5GHz radio band.
Use the spinner control to define a threshold (between 1 - 100) the access
point uses (when exceeded) to initiate channel load balancing in the 5GHz
radio band. Set this value higher when wishing to keep radio traffic within
their current channel designations. The default is 5%.
Use the spinner control to assign a weight (between 0 - 100%) the access
point uses to prioritize 5GHz radio client count in the 5GHz radio load
calculation. Assign this value higher this 5GHz radio is intended to support
numerous clients and their throughput is secondary to maintaining client
association. The default setting is 90%.
Use the spinner control to assign a weight (between 0 - 100%) the access
point radio uses to prioritize 5GHz radio throughput in the load calculation.
Assign this value higher if throughput and radio performance are
considered mission critical and more important than a high client
connection count. The default setting is 10%.
values within the Advanced Parameters field:
Use the spinner control to set the access point radio threshold value (from
0 - 100%) used to initiate load balancing across other radios. When the
radio load exceeds the defined threshold, load balancing is initiated. The
default is 5%.
Use the spinner control to set a value (between 0 - 100%) considered an
adequate discrepancy (or deviation) when comparing access point radio
load balances. The default setting is 1%. Thus, using a default setting of
10% means 10% is considered inconsequential when comparing access
point radio load balances.
Use the spinner control to assign a weight (between 0 - 100%) the access
point uses to prioritize client count in the radio load calculation (on both the
2.4 and 5 GHz radio bands). Assign this value higher if this radio is intended
to support numerous clients and their throughput is secondary to
maintaining client association. The default setting is 90%.
Device Configuration 5 - 147