Motorola WiNG 5 System Reference Manual page 205

Use notifications from
roamed clients
Use smart-rf neighbor
detection
Use smart-rf neighbor
detection
4. Select Balance AP Loads
radio load by band ratio allows an administrator to assign a greater weight to radio traffic on either the 2.4 or 5 GHz
band. This setting is enabled by default.
5. Set the following Channel Load Balancing
Balance 2.4GHz Channel
Loads
Balance 5GHz Channel
Loads
6. Select Balance AP Loads
radios. This setting is disabled by default, keeping the load on this access point radio.
7. Set the following Band Control
Max. Band Load
Difference Considered
Equal
Band Ratio (2.4GHz)
Select this option to use roamed client notifications in the neighbor
selection process. This feature is enabled by default, allowing access
points in the neighbor selection process to consider device roaming counts
as selection criteria.
Select this option to use SMART RF access point transmission adjustments
as criteria in the neighbor selection process. This feature is enabled by
default.
Select this option to use WIPS client blacklist and events as criteria in the
neighbor selection process. This feature is enabled by default.
to balance the radio load, by assigning a ratio to both the 2.4 and 5GHz bands. Balancing
settings:
Select this option to balance loads across channels in the 2.4 GHz radio
band. This can prevent congestion on the 2.4 GHz radio if a channel is over
utilized. This setting is enabled by default. Selecting this feature enables
parameters within the Channel Load Balancing field for assigning
weightage and throughput values.
Select this option to balance loads across channels in the 5 GHz radio band.
This can prevent congestion on the 5 GHz radio if a channel is over utilized.
This setting is enabled by default. Selecting this feature enables
parameters within the Channel Load Balancing field for assigning
weightage and throughput values.
radio button to distribute the this access point radio load amongst other access point
values within the Advanced Parameters
Use the spinner control to set a value (between 0 - 100%) considered an
adequate discrepancy (or deviation) when comparing 2.4 and 5GHz radio
band load balances. The default setting is 1%. Thus, using a default setting
of 10% means 10% is considered inconsequential when comparing 2.4 and
5 GHz load balances on this access point. This setting is not available if the
Steering Strategy has been set to Disable.
Use the spinner control to set a loading ratio (between 0 - 10) the access
point 2.4 GHz radio uses in respect to radio traffic load on the 2.4 GHz band.
This allows an administrator to weight the traffic load if wishing to
prioritize client traffic on the 2.4 GHz radio band. The higher the value set,
the greater the weight assigned to radio traffic load on the 2.4 GHz radio
band. The default setting is 1. This setting is only enabled when Steer by
ratio is selected as the Steering Strategy.
Device Configuration 5 - 145
field.