Motorola WiNG 5 System Reference Manual page 212

5 - 152 WiNG 5 Access Point System Reference Guide
8. Set the following Link IP parameters to complete the MINT network address configuration:
IP
Port
Routing Level
Listening Link
Forced Link
Link Cost
Hello Packet Interval
Adjacency Hold Time
IPSec Secure
Figure 5-84 Advanced Profile MINT screen - Add IP MiNT Link
Define the IP address used by peer access points for interoperation when
supporting the MINT protocol.
To specify a custom port for MiNT links, select this Port radio button and
use the spinner control to define the port number (1 - 65,535).
Use the spinner control to define a routing level of either 1 or 2.
Specify a listening link of either 0 or 1. UDP/IP links can be created by
configuring a matching pair of links, one on each end point. However, that
is error prone and doesn't scale. So UDP/IP links can also listen (in the TCP
sense), and dynamically create connected UDP/IP links when contacted.
Select this box to specify the MiNT link as a forced link.
Use the spinner control to define a link cost between 1 - 10,000. The default
value is 100.
Set an interval in either Seconds (1 - 120) or Minutes (1 - 2) for the
transmission of hello packets. The default interval is 15 seconds.
Set a hold time interval in either Seconds (2 - 600) or Minutes (1 - 10) for
the transmission of hello packets. The default interval is 46 seconds.
Select this option to use a secure link for IPSec traffic.