Motorola WiNG 5 System Reference Manual page 210

5 - 150 WiNG 5 Access Point System Reference Guide
3. Define the following
Designated IS Priority
Adjustment
4. Select the
the spinner control used for defining a latency period between 0 - 60 seconds. The default setting has the check
box disabled.
5. Define the following
MLCP IP
MLCP VLAN
6. Select OK
7. Select the
point's MINT configuration.
Device Heartbeat Settings
Use the spinner control to set a Designated IS Priority Adjustment setting
between -255 and 255. This is the value added to the base level DIS priority
to influence the Designated IS (DIS) election. A value of +1 or greater
increases DISiness. The default setting is 0.
Latency of Routing Recalculation
MINT Link Settings
Check this box to enable MINT Link Creation Protocol (MLCP) by IP Address.
MLCP is used to create one UDP/IP link from the device to a neighbor. The
neighboring device does not need to be a Virtual Controller, it can be an
standalone access point.
Check this box to enable MLCP by VLAN. MINT Link Creation Protocol is
used to create one VLAN link from the device to a neighbor. The neighboring
device does not need to be a Virtual Controller, it can be an standalone
access point.
to save the changes made to the Settings tab. Select
IP tab to display the link IP network address information shared by the devices managed by the access
in respect to devices supported by the controller profile:
check box (within the Shortest Path First (SPF)
in respect to devices supported by the controller profile
Reset
field) to enable
to revert to the last saved configuration.