Motorola WiNG 5 System Reference Manual page 304

5 - 244 WiNG 5 Access Point System Reference Guide
15. Set the OSPF Area
Area ID
Authentication Type
Type
Default Cost
Translate Type
Range
16. Select the
configuration.
17. Select the
Figure 5-134 OSPF Area Configuration screen
configuration.
Use the drop down menu and specify either an IP address or Integer for the
OSPF area.
Select either None, simple-password or message-digest as credential
validation scheme used with the OSPF dynamic route. The default setting is
None.
Set the OSPF area type as either stub, totally-stub, nssa, totally-nssa or
non-stub.
Select this option to set the default summary cost advertised if creating a
stub. Set a value from 1 - 16, 777,215.
Define how messages are translated. Options include translate-candidate,
translate always and translate-never. The default setting is
translate-candidate.
Specify a range of addresses for routes matching address/mask for OSPF
summarization.
OK button to save the changes to the area configuration. Select
Interface Settings tab.
Reset to revert to the last saved