Motorola WiNG 5 System Reference Manual page 332

5 - 272 WiNG 5 Access Point System Reference Guide
16. Set or override the following to define the Dynamic NAT configuration:
Source List ACL
Network
Interface
Overload Type
NAT Pool
Overload IP
Figure 5-153 Source NAT screen
Use the drop-down menu to select an ACL name to define the packet
selection criteria for NAT. NAT is applied only on packets which match a
rule defined in the access-list. These addresses (once translated) will not
be exposed to the outside world when the translation address is used to
interact with the remote destination.
Select Inside or Outside NAT as the network direction for the dynamic NAT
configuration. Inside is the default setting.
Select the VLAN (between 1 - 4094) or WWAN used as the communication
medium between the source and destination points within the NAT
configuration. Ensure the VLAN selected adequately supports the intended
network traffic within the NAT supported configuration.
Select the radio button of Overload Type used with the listed IP ACL rule.
Options include NAT Pool, One Global Address and Interface IP Address.
Interface IP Address is the default setting.
Provide the name of an existing NAT pool for use with the dynamic NAT
configuration.
If One Global IP Address is selected as the Overload Type, define an IP
address used a filter address for the IP ACL rule.