Table of Contents
Advertisement
Destination Port
NAT IP
NAT Port
Network
15. Select
OK
to save the changes made to the static NAT configuration. Select
configuration.
16. Select the
Dynamic NAT
Dynamic NAT configurations translate the IP address of packets going out from one interface to another interface
based on configured conditions. Dynamic NAT requires packets be switched through a NAT router to generate
translations in the translation table.
Use the spinner control to set the local port number used at the (source)
end of the static NAT configuration. The default value is port 1.
Enter the IP address of the matching packet to the specified value. The IP
address modified can be either source or destination based on the
direction specified.
Enter the port number of the matching packet to the specified value. This
option is valid only if the direction specified is destination.
Select Inside or Outside NAT as the network direction. Inside is the default
setting.
tab.
Device Configuration 5 - 119
Reset
to revert to the last saved
Hide quick links:
Advertisement
Table of Contents
