Motorola WiNG 5 System Reference Manual page 77

7. Set the following Ethernet port Properties:
Description
Admin Status
Speed
Duplex
Figure 5-7 Ethernet Ports - Basic Configuration screen
Enter a brief description for the port (64 characters maximum). The description
should reflect the port's intended function to differentiate it from others with
similar configurations.
Select the Enabled radio button to define this port as active to the profile it
supports. Select the Disabled radio button to disable this physical port in the
profile. It can be activated at any future time when needed.
Select the speed at which the port can receive and transmit the data. Select
either 10 Mbps, 100 Mbps, 1000 Mbps. Select either of these options to
establish a 10, 100 or 1000 Mbps data transfer rate for the selected half duplex
or full duplex transmission over the port. These options are not available if
Auto is selected. Select Automatic to enable the port to automatically
exchange information about data transmission speed and duplex capabilities.
Auto negotiation is helpful when in an environment where different devices
are connected and disconnected on a regular basis. Automatic is the default
setting.
Select either half, full or automatic as the duplex option. Select Half duplex to
send data over the port, then immediately receive data from the same direction
in which the data was transmitted. Like a full-duplex transmission, a
half-duplex transmission can carry data in both directions, just not at the same
time. Select Full duplex to transmit data to and from the port at the same time.
Using full duplex, the port can send data while receiving data as well. Select
Automatic to enable to the access point to dynamically duplex as port
performance needs dictate. Automatic is the default setting.
Device Configuration 5 - 17