Motorola WiNG 5 System Reference Manual page 338

5 - 278 WiNG 5 Access Point System Reference Guide
11. Refer to the
Configuration Update
Firmware Update
12. Use the parameters within the
firmware upgrade from a controller based file.
Select AP Type(s) for
Auto Upgrade
Number of Concurrent
Upgrades.
13. Select OK
Reset to revert to the last saved configuration.
Figure 5-156 Profile Overrides - Management Firmware screen
Auto Install via DHCP Option
Select the Configuration Update check box to enable automatic
configuration file updates for the controller profile from a location external
to the access point.
If enabled (the setting is disabled by default), provide a complete path to
the target configuration file used in the update.
Select this option to enable automatic firmware updates from a user
defined remote location. This value is disabled by default.
Automatic Adopted AP Firmware Upgrade
Select the access point model to upgrade to a newer firmware version
using its associated Virtual Controller AP's most recent firmware file for
that model. This parameter is enabled by default.
Use the spinner control to define the maximum number (1 - 20) of adopted
APs that can receive a firmware upgrade at the same time. Keep in mind
that during a firmware upgrade, the access point is offline and unable to
perform its normal wireless client support function until the upgrade
process is complete.
to save the changes and overrides made to the profile's Management Firmware configuration. Select
field to define automatic configuration file and firmware updates.
field to define an automatic