Table of Contents
Advertisement
24. Define a
Reduced Interframe Spacing (RIFS)
interframe spacing is applied to transmissions or received packets, or both or none. The default mode is Transmit and
Receive.
Consider setting this value to None for high priority traffic to reduce packet delay.
25. Set or override the following
connected wireless clients:
Non-Unicast Transmit
Rate
Non-Unicast
Forwarding
26. Refer to the
Sniffer Redirect (Packet Capture)
Host for Redirected
Packets
Channel to Capture
Packets
27. Select
OK
to save or override the changes to the Advanced Settings screen. Select
configuration.
mode using the drop-down menu. This value determines whether
Non-Unicast Traffic
values for the profile's supported access point radio and its
Use the Select drop-down menu to launch a sub screen to define the data rate
broadcast and multicast frames are transmitted. Seven different rates are
available if the not using the same rate for each BSSID, each with a separate
menu.
Define whether client broadcast and multicast packets should always follow
DTIM, or only follow DTIM when using Power Save Aware mode. The default
setting is Follow DTIM.
field to define or override the radio's captured packet configuration.
If packets are re-directed from a access point radio, define an IP address of a
resource (additional host system) used to capture the re- directed packets. This
address is the numerical (non DNS) address of the host used to capture the
re-directed packets.
Use the drop-down menu to specify the channel used to capture re-directed
packets. The default value is channel 1.
Device Configuration 5 - 213
Reset
to revert to the last saved
Hide quick links:
Advertisement
Table of Contents
