Table of Contents
Advertisement
7 - 6
WiNG 5 Access Point System Reference Guide
Incoming Packets
8. Set the following
criteria. Optionally fallback to destination based routing if no hop resource is available.
Next Hop (Primary)
Next Hop
(secondary)
Default Next Hop
Fallback to
Destination Routing
Mark DSCP
9. Select
OK
configuration.
10.Select the
Select this option to enable radio buttons used to define the interfaces
required to receive route-map packets. Use the drop-down menu to define
either the access point's wwan1 or pppoe1 interface. Neither is selected
by default. Select the VLAN ID option to define the access point VLAN used
to
Action Clauses
to determine the routing function performed when a packet satisfies match
Define a first hop priority request. Set either the IP address of the virtual
resource or select the
pppoe1 or a VLAN interface. In the simplest terms, if this primary hop
resource is available, its used with no additional considerations.
If the primary hop request were unavailable, a second resource can be
defined. Set either the IP address of the virtual resource or select the
Interface
option and define either a wwan1, pppoe1 or a VLAN interface.
If a packet subjected to PBR does not have an explicit route to the
destination, the configured default next hop is used. This value is set as
either the IP address of the next hop or the outgoing interface. Only one
default next hop can be defined. The difference between the next hop and
the default next-hop is in case of former, PBR occurs first, then destination
based routing. In case of the latter, the order is reverse. Set either the next
hop IP address or define either a wwan1, pppoe1 or a VLAN interface.
It may be a good idea to select this option to enable the access point to
default back to destination based routing if none of the defined hop
resources are reachable. Packets are dropped if a next hop resource is
unavailable and fallback to destination routing is disabled. This option is
enabled by default.
Select this option and use the spinner control to set IP DSCP bits for QoS
using an ACL. The mark action of the route maps takes precedence over the
mark action of an ACL.
to save the updates to the route-map configuration. Select
General
tab from within the Policy Based Routing screen.
Interface
option and define either a wwan1,
Reset
to revert to the last saved
Hide quick links:
Advertisement
Table of Contents
