Motorola WiNG 5 System Reference Manual page 193

5. Ensure the Activate Critical Resources Policy
configuration. This option needs to remain selected to apply the configuration to the access point profile.
6. Click the Add button at the bottom of the screen to add a new critical resource and connection method, or select and
existing resource and select
Figure 5-75 Critical Resources screen - Adding a Critical Resource
7. Select the IP checkbox (within the Monitor Via field at the top of the screen) to monitor a critical resource directly
(within the same subnet) using the provided critical resource IP address as a network identifier.
8. Select the Interface checkbox (within the Monitor Via field at the top of the screen) to monitor a critical resource using
either the critical resource's VLAN, WWAN1 or PPPoE1 interface. If VLAN is selected, a spinner control is enabled to
define the destination VLAN ID used as the interface for the critical resource.
9. Use the Resource Detection
Options include Any and All. If selecting Any, an event is generated when the state of any single critical resource
changes. If selecting All, an event is generated when the state of all monitored critical resources change.
10. Select + Add Row to define the following for critical resource configurations:
IP Address
button is selected to enable the parameters within the screen for
Edit to update the resource's configuration.
drop-down menu to define how critical resource event messages are generated.
Provide the IP address of the critical resource. This is the address used by
the access point to ensure the critical resource is available. Up to four
addresses can be defined.
Device Configuration 5 - 133