Motorola WiNG 5 System Reference Manual page 557

Module
Source
Device
NOTE: Leave the Source, Device and Mobile Unit fields at the default setting of
00:00:00:00:00:00 to allow all MAC addresses.
3. Select the Add to Active Filters
added, the filter uses the configuration defined in the Customize Event Filters field.
4. Refer to the Active Event Filters
a. To activate all the events in the Active Events Filters table, select the
generation, select Disable All
b. To enable an event in the Active Event Filters table, click the event, then select the
button.
NOTE: Filters cannot be persisted across sessions. They must be created every time a
new session is established.
Select the module from which events are tracked. When a single module is
selected, events from other modules are not tracked. Remember this when
interested in events generated by a particular module. Individual modules can
be selected (such as TEST, LOG, FSM etc.) or all modules can be tracked by
selecting All Modules.
Set the MAC address of the source device being tracked. Setting a MAC
address of 00:00:00:00:00:00 allows all devices to be tracked.
Set the device MAC address for the device from which the source MAC
address is tracked. Setting a MAC address of 00:00:00:00:00:00 allows all
devices.
button to create a new filter and add it to the
table to set the following parameters:
Events.
Diagnostics 11 - 3
Active Event Filters
Enable All Events button. To stop event
Activate Defined Filter
table. When