Motorola WiNG 5 System Reference Manual page 39

13.Set the following DHCP and Static IP Address/Subnet information for the WAN interface:
• Use DHCP - Select the checkbox to enable an automatic network address configuration using the access point's
DHCP server. AP-6511 and AP-6521 model access points do not have an onboard DHCP server and an external DHCP
server must be utilized.
• Static IP Address/Subnet - Enter an IP Address/Subnet and gateway for the access point's WAN interface. These
are required fields
• The port connected to the WAN - Select the port used as the physical access point connection to the external
network. This ports available differ depending on the access point model deployed. Access point models with a
single port have this option fixed.
• Enable NAT on the WAN Interface - Select the checkbox to allow traffic to pass between the access point's WAN
and LAN interfaces.
14.Select Next. The Initial AP Setup Wizard displays the
2.4GHz radio band, 5GHz radio band or to set the radio's functionality as a dedicated sensor.
NOTE: The Radio Configuration screen displays separate configurable fields for each
access point radio. Supported access point models can have from one to three (AP-7131)
radios. The
radio has been dedicated as a sensor.
ADSP Sensor Support field displays at the bottom of the screen only if a
Radio Configuration screen to define radio support for the
Quick Start 3 - 11