Motorola WiNG 5 System Reference Manual page 451

• Default next hop - If a packet subjected to PBR does not have an explicit route to the destination, the configured default
next hop is used. This can be either the IP address of the next hop or the outgoing interface. Only one default next hop
can be defined. The difference between the next hop and the default next-hop is in case of former, PBR occurs first,
then destination based routing. In case of the latter, the order is reversed. With both cases:
a. If a defined next hop is reachable, it's used. If fallback is configured refer to (b).
b. Do normal destination based route lookup. If a next hop is found its used, if not refer to (c)
c. If default next hop is configured and reachable, it's used. If not, drop the packet.
• Fallback - Fallback to destination based routing if none of the configured next hops are reachable (or not configured).
This is enabled by default.
• Mark IP DSCP - Set IP DSCP bits for QoS using an ACL. The mark action of the route maps takes precedence over the
mark action of an ACL.
NOTE: A packet should optimally satisfy all the match criteria, if no match clause is
defined in a route-map, it would match everything. Packets not conforming to any of the
match clauses are subjected to normal destination based routing.
To define a PBR configuration:
1. Select Configuration >
The Policy Based Routing
2. Either select Add to create a new PBR configuration,
Delete to remove a selected PBR configuration.
Network.
screen displays by default.
Figure 7-1 Policy Based Routing screen
Network Configuration
Edit to modify the attributes of an existing PBR configuration or
7 - 3