Motorola WiNG 5 System Reference Manual page 330

5 - 270 WiNG 5 Access Point System Reference Guide
Destination Port
NAT IP
NAT Port
Network
13. Select OK
last saved configuration.
14. Select the
Dynamic NAT configurations translate the IP address of packets going out from one interface to another interface
based on configured conditions. Dynamic NAT requires packets be switched through a NAT router to generate
translations in the translation table.
Use the spinner control to set the local port number used at the (source)
end of the static NAT configuration. The default value is port 1.
Enter the IP address of the matching packet to the specified value. The IP
address modified can be either source or destination based on the
direction specified.
Select the radio button and enter the port number of the matching packet
to the specified value. This option is valid only if the direction specified is
destination.
Select Inside or Outside NAT as the network direction. Inside is the default
setting.
to save the changes or overrides made to the static NAT configuration. Select Reset to revert to the
Dynamic NAT tab.