Voice Vlan Refresh - Cisco 300 Series Cli Manual

Voice VLAN Commands
OL-32830-01 Command Line Interface Reference Guide
Example 5 —The following example sets the Voice VLAN state to auto-triggered
on IPv6. The VLANs are re-activated after auto SmartPort state is applied.
switchxxxxxx(config)# voice vlan state auto-triggered ipv6
switchxxxxxx(config)# 30-Apr-2011 00:13:52 %LINK-I-Up:
30-Apr-2011 00:13:52 %LINK-I-Up:
30-Apr-2011 00:13:52 %LINK-I-Up:
30-Apr-2011 00:13:52 %LINK-I-Up:
57.4

voice vlan refresh

To restart the Voice VLAN discovery process on all the Auto Voice VLAN-enabled
switches in the VLAN by removing all externally learned voice VLAN attributes and
resetting the voice VLAN to the default voice VLAN, use the voice vlan refresh
Global Configuration mode command.
Syntax
voice vlan refresh
Parameters
This command has no arguments or keywords
Default Configuration
None
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# voice vlan refresh
switchxxxxxx(config)#
30-Apr-2011 02:01:02 %VLAN-I-ReceivedFromVSDP: Voice VLAN updated by VSDP. Voice
VLAN-ID 100, VPT 5, DSCP 46 (Notification that Agreed Voice VLAN is updated)
(Auto Smartport configuration is changed)
Vlan 8
Vlan 9
Vlan 100
57
Vlan 5
1100