Configuring Optional Lldp Parameters - Cisco Nexus 7000 Series Configuration Manual

Configuring Optional LLDP Parameters

Step 6
Configuring Optional LLDP Parameters
You can configure the frequency of LLDP updates, the amount of time for a receiving device to hold the
information before discarding it, and the initialization delay time. You can also select the TLVs to include in
LLDP packets.
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Cisco Nexus 7000 Series NX-OS System Management Configuration Guide
364
Command or Action
switch(config)# copy running-config
startup-config
Command or Action
switch# configure terminal
switch(config)# [no] lldp
holdtime seconds
switch(config)# [no] lldp reinit
seconds
switch(config)# [no] lldp timer
seconds
switch(config)# show lldp timers
switch(config)# [no] lldp
tlv-select tlv
Purpose
(Optional)
Copies the running configuration to the startup
configuration.
Purpose
Enters global configuration mode.
(Optional)
Specifies the amount of time in seconds that a receiving
device should hold the information sent by your device
before discarding it.
The range is 10 to 255 seconds; the default is 120 seconds.
(Optional)
Specifies the delay time in seconds for LLDP to initialize
on any interface.
The range is 1 to 10 seconds; the default is 2 seconds.
(Optional)
Specifies the transmission frequency of LLDP updates in
seconds.
The range is 5 to 254 seconds; the default is 30 seconds.
(Optional)
Displays the LLDP hold time, delay time, and update
frequency configuration.
(Optional)
Specifies the TLVs to send and receive in LLDP packets.
The available TLVs are dcbxp, management-address,
port-description, port-vlan, system-capabilities,
system-description, and system-name. All available TLVs
are enabled by default.
Configuring LLDP