Lldp Tlv-Select Power-Management - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

lldp tlv-select power-management

To to enable power negotiation through LLDP, use the lldp tlv-select power-management interface
command.
Syntax Description This command has no arguments or keywords.
Defaults
Enabled on POEP ports
Command Modes Interface level
Command History Release
12.2(54)SG
Usage Guidelines
You need to disable this feature if you do not want to perform power negotiation through LLDP.
This feature is not supported on non-POEP ports; the CLI is suppressed on such ports and TLV is not
exchanged.
Examples This example shows how to enable LLDP power negotiation on interface Gigabit Ethernet 3/1:
Switch# config t
Enter configuration commands, one per line.
Switch(config)# int gi 3/1
Switch(config-if)# lldp tlv-select power-management
Related Commands Command
lldp run
OL-27596 -01
lldp tlv-select power-management
Modification
Support was introduced on the Catalyst 4500 series switch.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
End with CNTL/Z.
Description
Cisco IOS Command Reference library.
lldp tlv-select power-management
2-401