Pstn Parameters; General Parameters - AudioCodes Mediant 1000B User Manual

Gateway & enterprise sbc
Hide thumbs Also See for Mediant 1000B:
Table of Contents

Advertisement

Char Conversion Table
Char Conversion
configure voip > gateway
dtmf-supp-service dtmf-
and-dialing > char-
conversion
[CharConversion]

65.10.6 PSTN Parameters

This subsection describes the device's PSTN parameters.
65.10.6.1

General Parameters

The general PSTN parameters are described in the table below.
Parameter
Trunk Name
config-voip > interface
<e1|t1|bri> name
[DigitalPortInfo_x]
Protocol Type
configure voip > interface e1-
t1|bri > protocol
[ProtocolType]
User's Manual
Table 65-55: Char Conversion Table Parameters
Defines Unicode-to-ASCII character conversion rules. The format of the
ini file table parameter is as follows:
[CharConversion]
FORMAT CharConversion_Index = CharConversion_CharName,
CharConversion_FirstByte, CharConversion_SecondByte,
CharConversion_ConvertedOutput;
[\CharConversion]
For more information, see ''Converting Accented Characters from IP to
Tel'' on page 615.
Table 65-56: General PSTN Parameters
Defines an arbitrary name for a trunk (where x denotes the trunk
number for the ini file parameter). This can be used to help you
easily identify the trunk.
The valid value is a string of up to 40 characters. The following
special characters can be used (without the quotes):
" " (space)
"." (period)
"=" (equal sign)
"-" (hyphen)
"_" (underscore)
"#" (pound sign)
By default, the value is undefined.
Defines the PSTN protocol for all the Trunks. To configure the
protocol type for a specific Trunk, use the ini file parameter
ProtocolType_x:
[0] NONE
[1] E1 EURO ISDN = ISDN PRI Pan-European (CTR4)
protocol
[2] T1 CAS = Common T1 robbed bits protocols including E&M
wink start, E&M immediate start, E&M delay dial/start and loop-
start and ground start.
[3] T1 RAW CAS
[4] T1 TRANSPARENT = Transparent protocol, where no
signaling is provided by the device. Timeslots 1 to 24 of all
trunks are mapped to DSP channels.
[5] E1 TRANSPARENT 31 = Transparent protocol, where no
signaling is provided by the device. Timeslots 1 to 31 of each
trunk are mapped to DSP channels.
1152
Mediant 1000B Gateway & E-SBC
Description
Document #: LTRT-27055

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents