Set Ip Dscp - Edge-Core ECS4810-12M Layer 2 Management Manual

E
XAMPLE
This example creates a policy called "rd-policy," uses the
specify the previously defined "rd-class," uses the set cos command to
classify the service that incoming packets will receive, and then uses the
police flow
burst rate to 4000 bytes, and configure the response to drop any violating
packets.
Console(config)#policy-map rd-policy
Console(config-pmap)#class rd-class
Console(config-pmap-c)#set cos 3
Console(config-pmap-c)#police flow 10000 4000 conform-action transmit
violate-action drop
Console(config-pmap-c)#
This command modifies the IP DSCP value in a matching packet (as

set ip dscp

specified by the
classification.
S
YNTAX
[no] set ip dscp new-dscp
new-dscp - New Differentiated Service Code Point (DSCP) value.
(Range: 0-63)
D S
EFAULT
None
C
OMMAND
Policy Map Class Configuration
C
OMMAND
The set ip dscp command is used to set the priority values in the packet's
ToS field for matching packets.
E
XAMPLE
This example creates a policy called "rd-policy," uses the
specify the previously defined "rd-class," uses the set ip dscp command to
classify the service that incoming packets will receive, and then uses the
police flow
burst rate to 4000 bytes, and configure the response to drop any violating
packets.
Console(config)#policy-map rd-policy
Console(config-pmap)#class rd-class
Console(config-pmap-c)#set ip dscp 3
Console(config-pmap-c)#police flow 10000 4000 conform-action transmit
violate-action drop
Console(config-pmap-c)#
command to limit the average bandwidth to 100,000 Kbps, the
match command). Use the no form to remove this traffic
ETTING
M
ODE
U
SAGE
command to limit the average bandwidth to 100,000 Kbps, the
– 1001 –
| Quality of Service Commands
C 38
HAPTER
class command to
class command to