Side Panels; Replacing The Side Panel Holder (Standard Seat) - Otto Bock 490E75 Series Service Manual

4.15

Side panels

4.15.1

Replacing the side panel holder (standard seat)

Prerequisites:
Switch off the control unit and deactivate the main fuse (see Page 15).
Remove the seat cushion.
Tools: Allen wrench size 4; torque wrench with Allen insert size 4
Removing the side panel holder (standard seat)
1) Remove the seat plate (see Page 74).
2) Loosen the thumb screw on the side panel holder (see Fig. 213/214, item 1).
3) Pull the side panel up and out of the side panel holder. If necessary, remove or open the cable attachments along
the side panel (see Fig. 213, item 2).
4) Loosen the 2 clamping screws on the side panel holder (see Fig. 214, item 2).
5) Pull the side panel holder out of the seat frame (see Fig. 214, item 3).
Installing the side panel holder (standard seat)
1) Slide the side panel holder into the seat frame (see Fig. 214, item 3).
INFORMATION: Evenly slide the side panel holders into the seat frame according to the original seat
width.
2) Firmly tighten the 2 clamping screws on the side panel holder (see Fig. 214, item 2).
3) Slide the side panel into the side panel holder from above.
4) If necessary: Route the cable along the side panel according to its original installed position and reattach or
close the loosened cable attachments (see Fig. 213, item 2).
5) Firmly tighten the thumb screw on the side panel holder (see Fig. 213/214, item 1).
6) Install the seat plate (see Page 74).
213
490E75=0_C
214
Service work
Ottobock | 101